Pioneer VSX-604S Operating Instructions Manual page 11

CONNECTIONS
IR Repeater connection
Connecting a supplied IR Repeater lets you also control other components with this unit's remote control.
NOTE:
To operate components not made by Pioneer, perform REMOTE SET UP (P. 29) after connecting an IR Repeater.
Remote control signals directed towards this unit or GU! operation signals are transmitted from the repeater as infrared signals,
enabling control of other components.
There are two kinds of infrared repeaters. Connect either or both to match the remote control requirements of different components.
MAIN-REPEATER
Use this to operate other components with this unit's remote
control or to operate using GUI on-screen indications.
Install on top of thus unit as shown in the figure.
) - Insert the REPEATER's
two pegs into the holes on
the top.
Install the REPEATER
laying on its side on the top.
MAIN-REPEATER
(ry)
The pegs are usually inserted
in the two rear holes.
Use the two front holes
when there's another
component on top of this
preventing easy
reception of the MAIN
REPEATER's infrared
signals.
Use this when a component operates incorrectly after receiving
a signal from this unit's remote control, or when it is difficult
for a component to receive signals from the Main-Repeater. NOTE:
Stick it directly on the remote control sensor window. To prevent possible damage, be careful to avoid accidentally
There are two MINI-REPEATER terminals. connecting the MINI-REPEATER to the MAIN-REPEATER terminals.
lf you need another Mini-repeater, contact your nearest
Pioneer Service Center.
MINI-REPEATER
fon SoedeeasnG) —
(bite 12Q:000 * 2 BS
= _=—= ver
Ee ey
I
© Core
VCR
®
——————
@ Remove the seal.
@ Stick onto the remote control
"R sensor window.
11
<ARB7022>