U-Line Echelon 2075DWRRSS User Manual page 19

Install the custom insert as follows:
Insert edges may be SHARP! Use care when installing.
1. Open drawer. Pull drawer gas-
ket out of groove (top edge of
drawer only). Start in the mid-
dle and pull outward, moving
toward the edge (Figure 18).
This may take some force, be
careful.
2. Remove the three screws
behind the gasket. Carefully pull
the top handle up and off. You
may discard the top handle as
it will be replaced with the full
handle.
3. Remove
screws and the lower handle
(Figure 19).
4. Remove existing panel and
cardboard spacer. The panel
and spacer are no longer
needed and may be discarded.
!
WARNING
the two outside
FULL HANDLE SHOWN
19
Figure 18
STANDARD
HANDLE
FULL HANDLE
Figure 19
DWR020