8.17 Removing the Heater
1 Remove the tub as per section 8.13.
2 Remove the wiring cover as per section 8.16.
3 Remove the element cover by removing the three
T10 torx screws and unclip the wiring harness from
the element cover.
4 Remove the two wires from the element thermal
limiters.
5 Remove the earth wire (there is a securing tab you
will need to depress to release)
6 The element will now pull out of the housing, you
can use the earth tab to pull the heater out, or use a
flat blade screwdriver to lever the heater out of the
tub, but take care not to damage the seal.
7 When reassembling, ensure the gasket is correctly
fitted to the element, and align the locating pin.
8 Push the element evenly around the edge to push fit
into the housing,
9 Reattach the limiter wiring and ensure the earth wire
is reattached to the element, then reassemble the
wiring cover.
IMPORTANT!
Ensure the earth (ground) wire is attached to the
element when reassembled.
An earth bond test can be done between the
heater earth and mains plug earth.
There is a hole in the wiring cover above the
heater earth to enable this to be done.
http://vimeopro.com/fisherpaykeltechnical/training-videos/
video/121782517
8 SERVICING PROCEDURES
locating pin
silicone gasket
Earth/ground
wire
59