Diagnostics; Entering Diagnostics - Fisher & Paykel DishDrawer DD60 Service Manual

6.1 Entering Diagnostics

1
To enter diagnostic mode, ensure there is nothing showing on the LED display, (power off at the
display), then press and hold the START/PAUSE
seconds, making sure that the START/PAUSE
button. (The two outside buttons)
2
In Diagnostics mode, the display sub mode (dP) is initially activated. Step through the sub
modes using the WASH SELECTOR
Press START/PAUSE
CONTROLS AND DISPLAY
CONTROLS AND DISPLAY
C MODEL DISPLAY
Single models
Single models
Double models
Double models
Display ('dP ')/Saved Faults
1
Press START/PAUSE
2
From here, START/PAUSE
3
Pressing the START/PAUSE
recent fault. The tub indicator shows which tub the fault was displayed on. "0" is displayed if no fault
is recorded.
4
Pressing the WASH SELECTOR
moves it to previously saved.
5
"Saved fault mode" shows previous saved fault. Delayed Start
6
Pressing the WASH SELECTOR
7
POWER button exits back to diagnostics mode (dP).
8
Press the POWER button again to exit diagnostic mode completely, or press WASH SELECTOR
9
button to go to the next sub mode menu.

6 DIAGNOSTICS

button is pressed slightly ahead of the POWER
button. Press POWER
button to enter any sub mode.
button and all the LEDs on the display light up.
button toggles between "Recent fault mode" and "Saved fault mode".
button initially enters "Recent Fault mode" and displays the most
button when in "Recent fault mode" clears the most recent fault and
button when in previous fault clears the previously saved fault.
and POWER buttons simultaneously for 5
button to exit diagnostics mode.
CONTROLS AND DISPLAY
CONTROLS AND DISPLAY
A MODEL DISPLAY
Single models
Single models
Double models
Double models
icon illuminates.
CONTROLS AND
CONTROLS AND
Single models
Single models
Double models
Double models
41