Removing The Tub; Installation Instructions - Fisher & Paykel DishDrawer DD603 Installation Instructions Manual

INSTALLATION INSTRUCTIONS

PLEASE NOTE: Your model of
Installation is similar for Integrated & Prefinished products for either Single or Double models.
referring to Single models only is highlighted in blue.
clearer instruction. FOR INTEGRATED PRODUCTS FOLLOW THE INTEGRATED PANEL PREPARATION
INSTRUCTIONS P/N 526608, BEFORE MOVING THE PRODUCT INTO THE CAVITY.
STEP 1:
MOVING THE PRODUCT INTO THE CAVITY
2
Be careful of
sharp edges.
DO NOT push
middle of drawer(s).
R
must be free to close completely. With overlapping
3
integrated drawer fronts a /
32
between drawer front and cabinetry.
STEP 2:

REMOVING THE TUB

The product may move. Mark chassis
position on cavity.
5
6
9
R
may differ from the model shown in the installation diagrams.
Installation diagrams have been simplified to enable
1
4
" (2.5mm) clearance must be maintained
(SINGLE MODELS ONLY).
7
8
Information
MOUNTING TAB OPTIONS
The mounting tabs are in pairs, one on each side of the product. They are
used to secure the product to the cavity sides. Installation requires two
sets of tab pairs be used, for example
would be optimum. A minimum installation requires that the
mounting tabs be used.
1
DOUBLE MODELS ONLY
If the top installation tabs
inserting into the top slots as shown. Ensure the tabs are fully
locked in place.
2
Optional Flexible Extrusion
If the cavity is 24" x 34
can be attached along the top and sides of the product. Open the
drawer(s) to expose the chassis trim. Remove extrusion backing
and adhere with the lip against the chassis trim edge.
3
3
Check cavity for any obstructions that may interfere with sliding
the product back. Loosen the feet DOUBLE MODELS ONLY.
4
Push product into cavity to suit adjacent cabinetry. Do not push
middle of drawer(s). Be sure inlet, drain hose(s) and power supply
cord are not restricted or damaged by carefully pulling them
through the services hole, while the product is being pushed back
into the cavity.
5
SINGLE MODELS ONLY. Gently open the drawer and mark the
chassis position on the cavity, before removing the tub.
6
Open the drawer (Bottom drawer in DOUBLE MODELS). Release
the tub by depressing the right hand tub clip and pushing it back
6" (150mm). Repeat on the left hand side.
7
Lift the tub up off the drawer runners.
8
Slide both runners back into the product.
9
Place the tub onto the floor.
For SINGLE MODELS, depending on the height of the cavity, the tub
will need to be supported, eg. on a chair.
READ THESE INSTRUCTIONS
COMPLETELY AND CAREFULLY.
A and B tab pairs. All tabs
C Mounting Tab Option
C are to be used, fit to the chassis by
1
/ " (610mm x 876mm) flexible extrusions
2
R
B
7