Table of Contents
Advertisement
_ INSTALLATIONINSTRUCTIONS
PLEASE NOTE. Yourmodel of DishDrawer® may differ from the model shown in the installation
diagrams. Installationis similar for all models for either Singleor Doublemodels, Irlom _to[_ cfclr f7
o S_glc _o(_s e@i s
9hlgh _- i_ b_e_ Installationdiagrams havebeen simplified to enable
clearer instruction. FORINTEGRATED P RODUCTS FOLLOW THEINTEGRATED PANELPREPARATION
INSTRUCTIONS P IN 526608, BEFORE MOVINGTHEPRODUCT INTOTHE CAVITY.
DishDrawer ®
READTHESEINSTRUCTIONS
COMPLETELY A ND CAREFULLY.
STEP I:
MOVING THEPRODUCTINTO THECAVITY
_WARNING!
Be careful of
sharp edges,
Important!
DO NOT push
middle of drawer(s).
MOUNTING
TAB OPTIONS
The mounting tabs are in pairs, one on each side of the product, They are
used to secure the product to the cavity sides. Installation requires two
sets of tab pairs be used, DOUBLE MODELS ONLY - _
and _
tab pairs
OR _
and _
tab pairs may be used. All tabs would be optimum.
II
tl
If the top installation tabs _
are to be used, fit to the chassis by
inserting into the top slots as shown.
Ensure the tabs are fully
locked in place.
Optional
Flexible
Extrusion
If the cavity is 24"x 34V2" (610mm x 876mm) flexible extrusions
can be attached along the top and sides of the product,
Open the
drawer(s) to expose the chassis trim,
Remove extrusion backing
and adhere to the side and top of DishDrawer®.
Refer to the
drawing for correct placement.
Be sure that extrusions do not prevent the drawer from closing
completely,
O
Check cavity for any obstructions that may interfere with sliding
the product back. DOUBLE MODELS ONLY- loosen the feet first.
II
Push product into cavity to suit adjacent cabinetry.
Do not push
middle of drawer(s),
Be sure inlet, drain hose(s) and power supply
cord are not restricted or damaged by carefully pulling all excess
length through the services hole, while the product is being pushed
back into the cavity,
FOR :;IN(}LE MODELS :h:,ck tha::th:, as:_ el
prod c:: s _ot
low_:.
[)o _ol_.:,t.
gl. o_.:,onyo
I r evvBen rovingl
;m
ioll_;cav
y,
STEP2:
REMOVING THETUB
k
_po_'tant!
(S_N_JLE }aOOELSONLY).
T_e _@_ct may move. }aa_Rchassis _osiitio_ o_'_ c avity
SIN_LE/\ODELSOHLY.
(_;_::lyo
_ h,@aw;rad
naklh
elassi
posliononl
e { wly, b(lore enovingl
e
Open the drawer (bottom drawer in DOUBLE MODELS). Release
the tub by depressing the right hand tub clip and pushing it back
13116"(30ram), Repeat on the left hand side.
D
Lift the tub up off the drawer runners.
Q
Slide both runners back into the product,
Placethe tub onto the floor,
fo
MODELS, d _p_{:l _gor tl_ h_ig o e
ewiy,
wi ee_ ohe s_@pode_: _-:(/on_c
_r,
Hide quick links:
Advertisement
Table of Contents
