Mazda MX-5 2024 Owner's Manual page 337

What to Do in Case of Emergency
Engine Does Not Start
Keep flames and sparks away from lead-acid battery cells and do not
allow metal tools to contact the positive (+) or negative (-) terminal of the
lead-acid battery when working near a lead-acid battery. Do not allow the
positive (+) terminal to contact the vehicle body.
Flames and sparks near lead-acid battery cells are dangerous. Hydrogen gas,
produced during normal lead-acid battery operation, could ignite and cause the
lead-acid battery to explode. An exploding lead-acid battery can cause serious burns
and injuries. Keep all flames including cigarettes and sparks away from lead-acid
battery cells.
Keep all flames and sparks away from lead-acid battery cells
because hydrogen gas is produced from lead-acid battery cells while charging the
lead-acid battery or adding lead-acid battery fluid.
Flames and sparks near lead-acid battery cells are dangerous. Hydrogen gas,
produced during normal lead-acid battery operation, could ignite and cause the
lead-acid battery to explode. An exploding lead-acid battery can cause serious burns
and injuries. Keep all flames including cigarettes and sparks away from lead-acid
battery cells.
Do not jump-start a frozen lead-acid battery or one with a low fluid level.
Jump-starting a frozen lead-acid battery or one with a low fluid level is dangerous. It
may rupture or explode, causing serious injury.
Connect the negative cable to a good ground point away from the lead-acid
battery.
Connecting the end of the second jumper cable to the negative (–) terminal of the
depleted lead-acid battery is dangerous.
A spark could cause the gas around the lead-acid battery to explode and injure
someone.
Route the jumper cables away from parts that will be moving.
Connecting a jumper cable near or to moving part (cooling fans) is dangerous. The
cable could get caught when the engine starts and cause serious injury.
CAUTION
Use only a 12 V booster system. You can damage a 12 V starter, ignition system, and
other electrical parts beyond repair with a 24 V power supply (two 12 V batteries in
series).
1. Make sure that the vehicle power is switched OFF.
2. Remove the hole cover.
8-13
MX-5_8ME4-EA-23L_Edition1_new 2023-8-31 16:47:34