Mazda MX-5 2024 Owner's Manual page 185

How to Use the Tire
Pressure Monitoring
System (TPMS)
Check the tire pressure
The current tire pressure can be
checked on the center display.
Refer to the Mazda Connect "Vehicle
Status Monitor".
Low tire pressure warning
When a tire pressure of the specified
air pressure or lower is detected, the
TPMS warning light
Action
1. Adjust the tire pressure to the
appropriate pressure.
Refer to the Tires on page 10-65.
CAUTION
If the tire pressure is adjusted when
the tire is warm, the tire pressure
may lower below the specified
pressure after cooling and the
warning light may turn on. Adjust
the air pressure of the tires when
they are cold.
2. Make sure that the TPMS warning
light is turned off.
3. If the TPMS warning light
not turn off, drive the vehicle for 3
minutes or longer at a speed of 25
km/h (16 mph) or faster.
4. Make sure that the TPMS warning
light is turned off.
If the TPMS warning light remains on
even after adjusting the tire pressure,
there is a possibility that the tire is flat.
MX-5_8ME4-EA-23L_Edition1_new
Tire Pressure Monitoring System (TPMS)
When inspecting/adjusting the tire
pressures, do not apply excessive force
to the air valve of the tire pressure
sensor. Otherwise, the tire pressure
sensor could be damaged.
When changing tires and wheels
When changing the tires or wheels
(such as installing winter tires), it will
be necessary to register the ID signal
code of the tire pressure sensor to the
TPMS.
Have an Authorized Mazda Dealer do
turns on. the registration or register the ID signal
codes of the tire pressure sensors using
the following procedure.
NOTE
The tire pressure sensors on each
wheel have a unique ID signal code.
For the TPMS to operate correctly, the
ID signal codes of the tire pressure
sensors need to be registered to the
system.
1. Wait more than 19 minutes after
2. After more than 19 minutes have
does
NOTE
If you drive the vehicle within 19
minutes of changing a tire or wheel,
the TPMS warning light
because the ID signal codes for the tire
pressure sensors were not registered.
In this case, stop the vehicle and
register the ID signal codes of the tire
pressure sensors following the
procedure.
CAUTION
changing a tire or wheel.
passed, drive the vehicle at a speed
of 25 km/h (16 mph) or faster for 3
minutes or longer. While driving,
the ID signal codes of the tire
pressure sensors are automatically
registered.
will flash
2023-8-31 16:47:34
Driving
5-77