Weber Summit E-470 Owner's Manual page 31

PROBLEH CHECK CURE
Burners burn with a yellow or orange Inspect Spider/Insect Screens for possible Clean Spider/Insect Screens. (See Section 'Annual Maintenance")
flame, in conjunction with the smell obstructions. (Blockage of holes.)
of gas (This is normal for the burner
lighting tube).
Sear Station burner does not light. Did you ignite the two adjacent main burners Verify adjacent main burner ignition by visual inspection of a flame.
(See Sear Station burner lighting instructions
for safe lighting procedure) z_ WARNING: if ignition does not occur in 5 seconds, turn burner control
OFF, wait 5 minutes to let the gas c/ear before you try again
Does Burner light with a match? If you can light Burner with a match, then check the Crossover ¢ Channel on the sear
burner. (See Maintenance for burner removal and cleaning procedure.)
Does the igniter work (Do you see a spark Try manually lighting the burner (refer to "Lighting the Rotisserie Burner"). Call
when you repeatedly use the snap igniter? customer service.
if problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our
web site. Log onto www.weber.com '_.
OPERATING THE HANDLE LIGHT
The Weber Grill Out
TM
Handle Light has a built-in "Tilt Sensor." With the power button (a)
activated, the light will come on when the grill lid is open. The light will turn off when the lid
is closed. For daytime use, deactivate the sensor by pressing power button (a).
PROBLEM CHECK
Weber Grill Out
TM
Handle Are the batteries old?
Light does not light.
Are the batteries installed correctly?
Is the lid in the up position with the power button ON?
Is the Weber Grill Out
TM
Handle Light activated?
Is the Weber Grill Out
TM
Handle Light positioned correctly on the handle?
if problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web
site. Log onto www.weber.com ®.
CURE
Replace batteries.
See assembly illustration.
Light will activate when lid is open.
Press the power button.
Adjust position (See assembly illustration).