Weber Summit E-470 Owner's Manual page 24

MGHTING THE SMOKER BURNER
DANGER
Failure to open the lid while igniting the grill, or not waiting
5 minutes to allow the gas to clear if the grill does not light,
may result in an explosive flare=up which can cause serious
bodily injury or death.
SMOKER BURNER SNAPIGNMON
Note: The control knob snap igniter creates a spark from the igniter electrode to the
burner lighting tube. You generate the energy for the spark by pushing in the control
knob and turning to "START/HI". This will ignite the smoker burner.
WARNING: Check hose before each use of grill for nicks,
cracking, abrasions or cuts. if the hose is found to be
damaged in any way, do not use the grill. Replace using only
Weber _ authorized replacement hose. Contact the Customer
Service Representative in your area using the contact
information on our web site. Log onto www.weber.com ®.
1) Open the grill lid.
2) Open smoker box lid.
3) Fill smoker with water soaked wood chunks or chips.
4) Make sure that all burner control knobs not being used are turned to "OFF". (Push
control knob in and turn clockwise to ensure that it is in the "OFF" position).
5) Turn on the gas at source.
WARNING: Do not lean over the open grill while lighting.
6) Push the control knob in and turn to "START/HI" until you hear the igniter snap -
continue to hold control knob in for two seconds. This action will spark the igniter,
the burner lighting tube and then main burner.
7) Check that the burner is lit by looking through the cooking grates. You should see
a flame. If burner does not light on first try, push control knob in and turn to OFF.
Repeat lighting procedure a second time
DANGER
*The grill illustrated may have slight
differences than the model purchased.
If the smoker burner does not light, turn the burner control
knob to "OFF" and wait 5 minutes to let the gas clear before
attempting to light.
TO EXTINGUISH
Push in and turn each burner control knob clockwise to "OFF" position. Turn gas supply
off at the source.
8) Close smoker cover after wood starts to smolder and turn control knob to "LOW".