Weber Summit E-470 Owner's Manual page 14

Hide thumbs Also See for Summit E-470:
Table of Contents

Advertisement

Available languages

Available languages

TYPE OF GAS
Your natural gas grill is factory built to operate using natural gas only. Never attempt to
operate your grill on gases other than the type specified
on the grill rating plates.
Your grill operates
at 4.5" of water column pressure. If replacement
of the hose
becomes necessary,
factory specified
parts are required.
See your local dealer.
For safety and design reasons, the conversion
of a Weber _ grill from operation
using
Natural gas to operation
using LP gas requires the change out of the entire gas supply
system of the grill. If this becomes
necessary, see your dealer for additional
information.
WHAT IS NATURAL GAS?
Natural gas, often called methane, is a safe modern fuel. Natural gas is supplied by your
local utility and should be readily available
if your house is already heated with gas.
PORTABLE
INSTALLATION
Weber _ recommends
moving the grill at least two (2) feet from the gas supply and
any combustible
surfaces.
After the gas supply has been run and checked for leaks in
accordance
to the assembly
instructions,
you are ready to grill. To connect the hose
to the gas supply, pull back the outer fitting, insert the hose fitting all of the way, and
release the outer fitting. This process will produce
a gas joint.
LEAK CHECK PREPARATION
CHECK THAT ALL BURNER VALVES ARE OFF
Valves are shipped in the "OFF" position, but you should check to be sure that they are
turned off. Check by pushing in and turning clockwise.
If they do not turn, they are off.
Proceed to the next step. If they do turn continue
turning them clockwise
until they stop,
then they are off. Proceed to the next step.
3
4
5
2
6
1
1
Swivel Connection
2
Install covers when hose is disconnected
3
Shut Off Valve
4
Coat this pipe nipple with gas resistant pipe dope
5
Socket
6
Male Connection
1
Socket
2
Sleeve
3
Push Sleeve Back
4
Plug
Push plug until sleeve snaps forward locking plug in socket.
(This turns on gas automatically.)
When properly
assembled the plug cannot be removed without pushing
the sleeve back.
To disconnect,
push sleeve back and pull out plug.
CHECK FOR GAS LEAKS
WARNING: The gas connections of your Summit e gas grill
have been factory
tested. We do however recommend
that
you leak check all gas connections
before operating
your
Summit ® gas grill.
REMOVE CONTROL PANEL
Part required: Phillips Screwdriver.
1) Remove the burner control knobs.
(A)
..

Advertisement

Table of Contents
loading

This manual is also suitable for:

Summit s-470

Table of Contents