Table of Contents
Advertisement
2
See Appendix A for connector pin
assignments.
Figure 1 The Back Panel
Connecting the Terminal
If you connect your computer to the
Aux port, you must change the Host
Port setup parameter to
Aux Port
(see Table 5).
Basic Terminal Operation
Figure 1 shows the connectors on the terminal's back panel. You can
connect a host computer or other serial device to either serial port with
a shielded serial interface cable fitted with a male 25-pin connector on
the terminal end.
D
Note The use of shielded 1/0 cables is required when connecting this
equipment to any and all optional peripheral or host devices. Failure to
do so might violate FCC rules.
•
Power
Connector
MODEM
<W
\ilil&IOiqjID.W
®
I
Modem
Port
®
\'HHHHlilHili. ®l
PARALLEL
AUX
K/B
®jiilililiiiliiiiili!
' ®
[fi]
I
I
Auxiliary Parallel
Keyboard
Port
Port
Connector
(ES Only)
To connect the terminal to your computer and to other external
devices, follow these steps:
1 Plug one end of the keyboard cable into your keyboard and the other
end into the keyboard connector.
D
Note Do not attempt to connect any keyboard except one of the
keyboards specifically offered with this terminal.
2 Connect your computer or modem to the Modem port.
3 Connect the printer:
• If
you have a serial printer, connect it to the Aux port.
• If
you have a parallel printer, connect it to the Parallel port.
4 Connect one end of the power cord to the three-pronged power
connector, and plug the other end into a grounded power outlet.
Composing Characters
8-33
Table B-7 Compose Character Sequences: Multinational Mode (ANSI Personalities), Continued
Comp.
Sequence
Multi·
ISO
ISO
ISO
ISO
Char.
Description
3-Key1
2·Key2
national
Latln·1
Latln·2
Latln·S
Cyrillic
Cyrillic
Turkish
One-half
1
2
•
•
•
•
Advertisement
Table of Contents
