The Machine Status Area (B); How To Monitor Automatic Liquid-Chemical Injections; Manual Control And Diagnostics Area (C); Figure 11 The Machine Status Area - Milnor MilTouch MWF36Z8 Operator's Manual

3.8.1.2

The Machine Status Area (B)

This area displays the current and desired water level and temperature for the step in progress, the
current cylinder motion, and the current state of each valve.
Figure 11. The Machine Status Area
3.8.1.2.1

How to Monitor Automatic Liquid-Chemical Injections

If your machine controls a pumped chemical sys-
tem, the controller automatically injects chemi-
cals from the pump system while the formula
runs.
You can monitor automatic liquid-chemical in-
jections in the Machine Status area. As the con-
troller injects a chemical into the machine, the
chemical's valve number illuminates, as shown
in Figure 12, page 19, until the programmed in-
jection time expires.
3.8.1.3

Manual Control and Diagnostics Area (C)

Use these buttons as explained in the following figure.
Pellerin Milnor Corporation
BNCLJO07.C05 0000187329 F.2 C.5 9/11/20, 10:31 AM Released
C... Chemical signals and chemical
flush valve. Numbers 1–8 indicate
a chemical is being injected. F indi-
cates a chemical flush is occurring.
Cm. . . Cylinder motion
Cs. . . Cylinder speed, in rotations per
minute. Displays "RS" during Rin-
®
Save extract deceleration.
D... Date and time
Dr. . . Drain indicators
Lc. . . Current level (percentage)
Ld. . . Desired level
M... Current machine status area
P...
Formula progress bar
S... Steam and cooldown indicators
Sn. . . Step name
Tc. . . Current temperature
Td. . . Desired temperature
W... Water valve indicators
BNCLJO11.C04 0000214843 C.2 C.5 F.2 9/11/20, 10:33 AM Released
Figure 12. Chemicals from Valves 1 and 2
Injecting
BNCLJO11.C03 0000213316 C.3 C.5 F.2 9/11/20, 10:35 AM Released
Normal Operation
Legend
19