Advertisement
Attach the feet to the underneath of the heater using the four 10mm
screws. The feet are paced at both ends of the case.
1 =
Power = 750W
2 =
Power = 1250W
1+2 =
Power = 2000W
3 =
Thermostat
Note: When heaters are turned on for the first time, or when they are turned on after
not being used for a prolonged period of time, it is normal for the heater to emit
some smell or fumes. This will disappear when the heater has been on a short
while. If the smell does not disappear, we advise to switch off the heater and contact
a specialist.
Follow the guidelines and choose a suitable location for the heater.
To set the thermostat:
1. Turn the thermostat dial fully clockwise to the maximum setting.
2. Turn the heater on using the power switches, once on these will illuminate.
For maximum heat setting, both switches should be on.
3. Once the desired room temperature has been reached, turn the thermostat
anti-clockwise until the thermostat "clicks off" and the lights on the switches
are seen to go out. The heater will keep the air temperature in the room at
the set temperature by switching on and off automatically.
Note: the heater does remain hot/warm for some time after the unit has been
switched off, please handle with care.
ASSEMBLY / INSTALLATION
OPERATION
3
2
1
Advertisement
