Table of Contents
Advertisement
For free-standing use: attach the feet to the underneath of the heater
using the four 10 mm screws. The feet are placed at the end of the case.
To wall-mount: Referring to the diagram opposite, draw a line
approximately 270mm long vertically on the wall to mark the centre point
of the heater. Draw two horizontal lines on the wall 264 mm apart, the top
line should be approx. 430mm long and the bottom line 495mm. The lower
line more than 50 mm from the floor.
•
On the upper line, drill holes 193 mm from the centre line, using a
7mm masonry bit, and insert a wall plug.
•
On the lower line, drill holes 246 mm from the centre line using a
7mm masonry bit, and insert a wall-plug.
•
Fix the two Top Slot brackets to the upper holes using the 35mm
screws provided, the brackets should be mounted as per the
picture below the diagram opposite with the L part facing inwards.
•
Fix the two L-shaped bottom brackets to the underside of the
heater using the 10 mm screws through the round hole in the
bracket next to the slot.
•
Hang the heater on the hook-brackets using the two slots.
•
The L-shaped brackets will now line up with the lower holes in the
wall. Attach to the wall using the other two 35mm screws.
2580
ASSEMBLY / INSTALLATION
Bracket Hole
3
Ver. 2 - 04/14
Advertisement
Table of Contents
