Table of Contents
Advertisement
IMPORTANT
Installer and Users please note:
These instructions should be read carefully and left with the
user of the product for future reference.
INSTALLATION
For free-standing use: Loosen the two screws in the wall-
mounting bracket, squeeze the top tabs together and
removed the bracket from the back of the heater. It is not
required for free-standing use. Attach each foot to the
underneath of the heater using the four 8mm screws.
To wall-mount: Referring to the diagram opposite, draw two
horizontal lines on the wall 190mm (7½") apart, the lower line
more than 200mm (8") from the floor.
On the both lines, drill holes 130mm (5") from the centre line,
using a 6mm (¼") masonry bit, and insert a wall plug.
Loosen the two screws, squeeze the top tabs together and
removed the bracket from the back of the heater.
Attach the bracket to the wall using the screws provided.
Attach the heater to the backet, at the lower fixing point first.
Push the top of the heater onto the backet which will snap
into place.
Tighten the two screws in the bracket to lock it in place.
Page 2
Advertisement
Table of Contents
