SMC Networks ISE20B Operation Manual page 65

Copy ready status
Press the
The copy source Pressure switch
Sending/
Receiving
Copy
completed
(Copy source)
Press the
button.
The copy can be made continuously
and the copy ready status can be
held even if the power supply is
turned off.
To complete the copy function,
press the and
simultaneously for 1 second or
longer.
[F97] Setting of selection of copy function completed
: When the copy destination pressure switch displays [Er13], it indicates a sending and receiving error of the copy function.
Press the and
the wiring and specifications of the switch and retry the copy function.
: When copy is conducted so that the analog output is used, set the FUNC terminal setting of the copy source pressure switch to Aout,
then conduct a copy. The FUNC terminal setting of the copy destination pressure switch will be Aout when the copy is complete.
Even though the power supply is turned OFF, the
copy ready status will be retained.
button to start copying.
Main display: Red
Main display: Red
buttons
buttons simultaneously for 1 second or longer to return to measurement mode. Then, check
-65-
The copy destination Pressure switch
•When completed
normally
•When error
occurs
(Copy source)
Press the and
buttons
simultaneously for
1 second or longer.
Measurement mode
Main display:
Green
Main display:
Green
Main display: Red
(Copy
destination)
When
completed
normally.
Press the
button.
No.PS※※-OMU0006-F