Panasonic PT-52DL10 Operating Instructions Manual page 64

Operating peripheral equipment using the remote control
(_) Setting to the remote using the step and set method
(When code not known):
1
+
Press and hold the POWER and ACTION keys
simultaneously for three full seconds.
After 3 seconds, all the illuminated mode keys
will begin to flash. Then let go of the POWER
and ACTION key.
CH
VOL_VOL
CH
_ Press the mode key.
2 _ _ _ _:_ Tbe modekeywi,,illuminate
steadily,all
others
% wi,,0oou,
3
V0L VOL
CH
Press VOL" D " key to step to the next code.
Press POWER to send a test signal in that
format.
Continue doing this until the proper device
code is found, And the target device responds.
VOL VOL
CH
Once the code has been found, press the
ACTION key to lock it in.
Notes:
• The step and set mode will start from the current device (not the beginning of
the library, except for the first time).
• The step and set mode works in the reverse direction using the VOL" <]" key.
Infrared Remote Codes for Specific Components
Helpful Hint: Write down the code numbers for your components in the space provided below. This will serve as a
handy reference whenever you need to repro_ram your remote control.
CABLE
Cable Box I
DBS
I
Digital Broadcast System I
I
Other Component
I
Other Component
r
t
i
i
VCR
J J VideoCassetteRecerderJ
RCVR
J J Receiver or Amplitier J
51 I
Other Component
II i
Other Componem
I II
I II
CD
oom_ac, Disc_,ayer I I I /
LD
I
Laser Disc Player I I I I
I I II
Other Component
I I LI
Olher Component
64