Chapter 30
Zone-to-Zone Cloning
Zone Cloning clones conventional zones from one radio to another.
You can select the followings zones from a source radio and clone them into a target radio.
•
Clone enabled zones
•
Dynamic Zones
•
Multiple Private Line (MPL)
You can clone the zones by connecting the source radio and target radio with a clone cable. The target
radio must be digital, band, and FCC mandate compatible with the source radio.
NOTE: This feature is applicable for Full Keypad models and Limited Keypad models.
30.1
Cloning Zones
Procedure:
1 Press the Clon menu item.
2 Press Sel.
If successfully connected to the target radio, the radio displays Target radio connected.
3 To accept the source zones selection, press Next.
4 Perform one of the following actions:
•
If you select a single source zone, press Sel to select the target zones for cloning.
•
If you select multisource zones, the display shows Confirm target and the automatically
selected target zones and source zones mapping.
•
If the selected multi-source zones exceed the last clone target zone, the radio displays <#>
src zones unselected, Sel exceed max tgt zone, and Protected tgts not
supported alternatively.
5 To begin cloning, press Clon.
If cloning is successful, your radio shows the following indications:
•
A tone sounds.
•
The display shows Clone successful and the source zone alias.
If cloning is unsuccessful, your radio shows the following indications:
•
A tone sounds.
•
The display shows Clone failed.
NOTE: The target radio enters programming mode during cloning and resets when cloning is
completed.
MN009203A01-AD
Zone-to-Zone Cloning
95