Table of Contents
Advertisement
MN009203A01-AD
Legal and Support
2 This device must accept any interference received, including interference that may cause undesired
operation.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio or TV technician for help.
For country code selection usage (WLAN devices)
NOTE: The country code selection is for non-US model only and is not available to all US
models. Per FCC regulation, all Wi-Fi products marketed in the US must be fixed to US
operation channels only.
Industry Canada WLAN Statement
CAUTION:
1 The device for operation in the band 5150–5250 MHz is only for indoor use to reduce the
potential for harmful interference to co-channel mobile satellite systems.
2 The maximum antenna gain permitted for devices in the bands 5250–5350 MHz and 5470–
5725 MHz shall be such that the equipment still complies with the e.i.r.p. limit.
3 The maximum antenna gain permitted for devices in the band 5752–5850 MHz shall be
such that the equipment still complies with e.i.r.p. limits specified for point-to-point and
non-point-to-point operation as appropriate.
4 The worst case tilt angle(s) necessary to remain compliant with the e.i.r.p. elevation mask
requirement set forth in Section 6.2.2 (3) shall be clearly indicated.
5 User should also be advised that high-power radars are allocated as primary users (i.e.
priority users) of the bands 5250–5350 MHz and 5650–5850 MHz and that these radars
could cause interference and/or damage to LE-LAN devices.
Important Safety Information
RF Energy Exposure and Product Safety Guide for Portable Two-Way Radios
CAUTION:
This radio is restricted to Occupational use only.
Before using the radio, read the RF Energy Exposure and Product Safety Guide for Portable
Two-Way Radios which contains important operating instructions for safe usage and RF
energy awareness and control for Compliance with applicable standards and Regulations.
For a list of Motorola Solutions-approved antennas, batteries, and other accessories, visit the following
website:
12
Advertisement
Table of Contents
