Jenn-Air W11528111A Installation Manual page 25

INSTALLATION
Wiring
Screws
cover
5
Unscrew the screws attaching wiring
cover to the ice maker and remove
the wiring cover. Place the screws and
wiring cover aside.
Drain 5/8" hose
pump clamp
6
Install vent tube [5/16" I.D. x 32" (81 cm)]
to drain pump reservoir vent. Use one
of the supplied 5/8" small adjustable
clamp.
NOTE:
Do not block air flow through the
■
vent tube by over tightening the
cable tie.
Vent
tube
Cable
tie
7
Route the vent tube through the
plastic retainer as shown in the
illustration. Using a cable tie, tie the
vent tube to the suction tube and
wires located behind the wiring cover.
Reinstall the wiring cover and screws.
NOTE:
Do not overtighten the vent tube, it
■
may block the airflow through tube.
Vent
tube
Plastic
retainer
8 Unscrew and remove the power cord
clamp mounted to the ice maker side
wall from the ice maker power cord.
Ice maker power cord,
clamp and screw
INSTALLATION | 25