Table of Contents
Advertisement
Ti300U, Ti400U, Ti401U, Ti480U
Users Manual
Ambient Temperature
Ambient Temperature refers to the air temperature between the Imager and the target.
To set Ambient Temperature:
1. Select Ambient Temperature.
2. Slide the screen up and down to set Ambient Temperature value to the actual air temperature.
F2
3. Push
Ambient Temperature is usually a default value, which needs to be set only when
the air temperature is higher than the actual temperature of the target under
measurement.
Selecte Scale Mode
The thermal imager provides the scale modes: Auto Range and Manual Range.
In the Auto range mode, the Imager uses the algorithm to automatically set the appropriate
upper/lower temperature value of the temperature span.
In the Manual range mode, the background of the upper/lower limit temperature values of the
temperature bar is gray, which is in the adjustable state. When the upper and/or lower temperature
value of the temperature bar have no gray background, they are in the locked state; Tap the
upper/lower temperature value to switch it to the locked or adjustable state.
The minimum temperature span In the Auto span mode is 3 °C and 2 °C in the Manual mode. The
imager supports touch selection and setting the upper and lower limit temperature values of the
temperature span.
Select Temperature Span Mode：
1. Select Select Scale mode menu.
2. Tap Auto or Manual.
F2
3. Push
To adjust temperature span manually.
When the Manual temperature span mode is selected, a scroll wheel shows on the right side of the
screen, as shown in
push
/
28
(Last) to return to the previous menu or push
(Last) to return the previous menu, or push
Figure
13. Slide the scroll wheel up or down to adjust the temperature span or
.
F3
Note
F3
(Cancel) to exit the menu.
(Cancel) to exit the menu.
Advertisement
Table of Contents
