Brother MFC-5440CN User Manual page 141

/
DIFFICULTY |SUGGESTIONS
PhotoCapture Center
TM
Difficulties (MFC-5840CN only)
Removable Disk does not a)Have you installed the Windows ® 2000 update?
work properly. If not, do the following:
1. Disconnect the USB cable.
2. Install the Windows ® 2000 update. Please see the Quick Setup
Guide. After the installation the PC will be automatically restarted.
3. Wait about 1 minute after you reboot the PC, and then connect the
USB cable.
b)Take out the media card and put it back in again.
c) If you have tried "Eject" from within Windows ®, you must take out the
media card before you continue.
d)lf an error message appears when you try to eject the media card, it
means the card is being accessed.
Wait a while and then try again.
e) If all of the above do not work, please turn off your PC and MFC, and
then turn them on again.
(You will have to unplug the power cord of the MFC to turn it off.)
Make sure you have inserted the media card into the media slot.
Cannot access Removable
Disk from Desktop icon.
Network Difficulties
I cannot print over the Network Make sure that your MFC is powered on and is On Line and in Ready
mode. Print Network Configuration list. (See Printing reports on page
7-1 .) Then the current settings of the network are printed. Reconnect the
LAN cable to the hub to verify that the cabling and network connections
are good. If possible, try connecting the MFC to a different port on your
hub using a different cable. If the connections are good, the machine
shows LAN Active for 2 seconds.
11 - 13 TROUBLESHOOTING AND ROUTINE MAINTENANCE