Before Installing The Hob; After Installing The Hob - Samsung NZ64R3747RK User Manual

Make sure the appliance is well ventilated and that air inlets and outlets are not
blocked.
In order to avoid accidental touch with the overheating bottom of the hob, or
getting unexpected electric shock during working, it is necessary to put a wooden
insert, fixed by screws, at a minimum distance of 25mm from the bottom of the
hob. Follow the requirements below.
Induction Hob
25 mm
Insulation Panel
Oven
WARNING
There are ventilation holes around outside of the hob. YOU MUST ensure these
holes are not blocked by the work surface when you put the hob into position.
WARNING
Be aware that the glue that joins the plastic or wooden material to the
•
furniture, has to resist to temperatures not below 150 ºC, to avoid the
paneling becoming unstuck.
•
The rear wall, adjacent and surrounding surfaces must therefore be able to
withstand a temperature of 90 ºC.
Min.25mm
min. 2 mm
ventilation gap

Before installing the hob

• The work surface is square and level, and no structural members interfere
with space requirements.
•
The work surface is made of a heat-resistant and insulated material.
If the hob is installed above an oven, the oven has a built-in cooling fan.
•
• The installation will comply with all clearance requirements and applicable
standards and regulations.
• A suitable isolating switch providing full disconnection from the mains power
supply is incorporated in the permanent wiring, mounted and positioned to
comply with the local wiring rules and regulations.
•
The isolating switch must be of an approved type and provide a 3 mm air gap
contact separation in all poles (or in all active [phase] conductors if the local
wiring rules allow for this variation of the requirements).
•
The isolating switch will be easily accessible to the customer with the hob
installed.
•
You consult local building authorities and by-laws if in doubt regarding
installation.
• You use heat-resistant and easy-to-clean finishes (such as ceramic tiles) for
the wall surfaces surrounding the hob.

After installing the hob

CAUTION
• The power supply cable is not accessible through cupboard doors or drawers.
•
There is adequate flow of fresh air from outside the cabinetry to the base of
the hob.
• If the hob is installed above a drawer or cupboard space, a thermal protection
barrier is installed below the base of the hob.
•
The isolating switch is easily accessible by the customer.
English 11