Table of Contents
Advertisement
installing the hob
Be sure the new appliance is installed and grounded only by qualified personnel.
Please observe this instruction. The warranty will not cover any damage that may
WARNING
occur as a result of improper installation.
Technical data is provided at the end of this manual.
SAFETY INSTRUCTIONS FOR ThE INSTALLER
•
With respect to fire protection, this appliance corresponds to EN 60 335 - 2 - 6. This
type of appliance may be installed with a high cupboard or wall on one side.
•
Drawers may not be fitted underneath the hob.
•
The installation must guarantee shock protection.
•
The kitchen unit in which the appliance is fitted must satisfy the stability requirements
of DIN 68930.
•
For protection against moisture, all cut surfaces are to be sealed with a suitable
sealant.
•
On tiled work surfaces, the joints in the area where the hob sits must be completely
filled with grout.
•
On natural, artificial stone, or ceramic tops, the snap action springs must be bonded
in place with a suitable artificial resin or mixed adhesive.
•
Ensure that the seal is correctly seated against the work surface without any gaps.
Additional silicon sealant must not be applied; this would make removal more difficult
when servicing.
•
The hob must be pressed out from below when removed.
12_ installing the hob
CTR432NB02_XSM_DG68-00315A-04_EN.indd 12
2016-11-04
2:58:19
Advertisement
Table of Contents
