Ricoh SP 201N Operating Instructions Manual page 20

1. Guide to the Machine
Security Method
Open System – WEP
Shared Key – WEP
*1 The key length, key format, and WEP key cannot be configured.
13. Enter [WEP Key / Passphrase (PSK):].
14. If it is necessary to configure the IPv4 address, click [IPv4 Configuration].
The IPv6 address can be configured only by using Web Image Monitor.
15. Click [OK].
After a setting is changed, the machine automatically restarts.
16. Using the Wi-Fi status report, you can check whether the connection has succeeded or
failed.
If [Wireless LAN Status Report:] is set to [On], a report confirming the completion of wireless LAN
setup is printed. If "OK" appears for "Connection", the connection has succeeded. If "Failed"
appears for "Connection", try configuring the settings again.
Connecting in Ad-hoc mode using control panel
1. Make sure the Ethernet cable is not connected to the machine.
2. Switch on the machine.
Go to the next step after the power indicator has flashed three times.
3. Hold down the [Job Reset] key.
Hold the key down for two seconds or longer makes the power indicator flash.
18
Key Length
64 bit ASCII
Hexadecimal
128 bit ASCII
Hexadecimal
64 bit ASCII
Hexadecimal
128 bit ASCII
Hexadecimal
Key Format
(Maximum character)
5 characters
10 characters
13 characters
26 characters
5 characters
10 characters
13 characters
26 characters
WEP Key