Table of Contents
Advertisement
Chapter 1 Getting Started
UTayer-ver dare
for ateXerc}inle mm Clelere me Meler-ticela)
To prevent internal heat buildup in the unit,
place the unit in a location with adequate air circulation.
Do not install the unit:
¢ near heat sources such as radiators or air ducts.
¢ in a place subject to direct sunlight, excessive dusi,
mechanical vibration or shock.
Do not place anything on top of the cabinet.
The top ventilation holes must be unobstructed for the
proper operation of the unit and to prolong the life of its
components.
Do not throw away the carton and packing material!
It will be an ideal container when transporting the system for
repair work, etc.
Checking the Supplied Accessories
After unpacking, check that the following accessories are
present.
©
FM Wire ANON
ou... ccceeceteeeeeseteeeeesettteteeeeennnees (1)
®:
-AMIOOD Antena si sieccsssusccsestecstecedpeen
deseo bornebtevetaescnte (1)
e
Remote commander RM-P321
(supplied with STR-D2090) ....... ccc eeesetesteeteerteenees (1)
e
Remote commander RM-U221
(supplied with STR-D1090) ........ cesses seteeteeneees (1)
©
Sony batteries SUM-3 (NS) oo... eee
eee es eceeeerte nes (2)
Inserting the Batteries into the Remote
Commander
Before operating remote commander, instail the batteries as
shown.
1 Open the cover.
To avoid damage caused by battery leakage and
corrosion
When the commander will not be used for a long time,
remove the batteries.
Battery life
Normal operation can be expected about a half year using
Sony SUM-3 (NS), and a year using Sony AM-3 (NW)
alkaline batteries.
When the batteries are run down, the remote commander
will not operate the unit. In this case, replace batteries with
new ones.
Selecting the AM Tuning Interval
The AM tuning interval is preset to 10 kHz. To use the
receiver where the frequency allocation system is based on
a 9 kHz interval, make the following adjustments.
1 Turn on the power and tune in any AM station.
2 Turn off the power.
3 Press the POWER button while pressing the "+" INDEX
SELECT/TUNING button.
To reset the AM tuning interval, repeat the above steps.
Caution
When the interval is changed, all preset stations which you
have memorized will be erased. After changing the interval,
be sure to preset the stations again.
Advertisement
Table of Contents
