Table of Contents
Advertisement
Precautions
On safety
© Operate the unit only on 120 V AC, 60 Hz.
¢ Should any solid object or liquid fall into the cabinet,
unplug the unit and have it checked by qualified
personnel before operating it any further.
© Unplug the unit from the wall outlet if it is not to be used
for an extended period of time. To disconnect the cord,
pull it out by grasping the plug. Never pull the cord itself.
© One blade of the plug is wider than the other for the
purpose of safety and will fit into the power outlet only
one way. If you are unable to insert the plug fully into the
outlet, contact your dealer.
© To detach the side panel, first disconnect the power cord
from the wall outlet. Remove the screws on both sides to
detach the panels and fasten the supplied screws into the
holes on the unit. (STR-GX909ES only)
To prevent internal heat buildup in the unit,
place the unit in a location with adequate air circulation.
Do not install the unit:
© near heat sources such as radiators or air ducts.
¢ in a place subject to direct sunlight, excessive dust,
mechanical vibration or shock.
Do not place anything on top of the cabinet.
The top ventilation holes must be unobstructed for the
proper operation of the unit and to prolong the life of its
components.
Do not throw away the carton and packing material!
It will be an ideal container when transporting the system for
repair work, etc.
On operation
Before making program source connections, be sure to turn
the power switch off and unplug the unit.
On cleaning the cabinet
Clean the cabinet, panel and controls with a soft cloth lightly
moistened with mild detergent solution. Do not use any type
of abrasive pad, scouring powder, or solvent such as
alcohol or benzine.
For the customers in the U.S.A.
For detailed safety precautions, see the "IMPORTANT
SAFEGUARDS' leaflet.
If you have any question or problem concerning your unit,
please consult your nearest Sony dealer.
Chapter 1 Getting Started
Ua} ey-lol dare,
Checking the Supplied Accessories
After unpacking, check that the following accessories are
present.
© FM Wire Antenna ...........sesescccescssceeseessccssecesseseessencesoes (1)
© AM J00P ANTENNA ......ceceessesesseseteetsesonscsessonsesereesecseseenes (1)
¢ Remote commander RM-P331 ..........csersscssecscssesersees (1)
© Sony batteries SUM-3 (NS) 0.0.0...
ccscserccectecereseeoees +..(2)
© Screws (STR-GXQOQES Oly) uu... sesscrscsessesseeeseesessones (4)
Natcyela clave Mm datom stat ecole (ctomlatcom (arc ats]nirel cs
Commander
Before operating remote commander, install the batteries as
shown.
2 Two size AA (R6) batteries
with correct polarity.
1 Open the cover.
To avoid damage caused by battery leakage and
corrosion
When the commander will not be used for a long time,
remove the batteries.
Battery life
Normal operation can be expected about a half year using
Sony SUM-3 (NS), and a year using Sony AM-3 (NW)
alkaline batteries.
When the batteries are run down, the remote commander
will not operate the unit. In this case, replace batteries with
new ones.
Selecting the AM Tuning Interval
The AM tuning interval is preset to 10 kHz. To use the
receiver where the frequency allocation system is based on
a 9 kHz interval, make the following adjustments.
1 Turn on the power and tune in any AM siation.
2 Turn off the power.
3 Press the POWER button while pressing the INDEX
SELECT/TUNING + button.
To reset the AM tuning interval, repeat the above steps.
Caution
When the interval is changed, all preset stations which you
have memorized will be erased. After changing the interval,
be sure to preset the stations again.
5
Advertisement
Table of Contents
