Table of Contents
Advertisement
acciexelaeliate Melatcom-lemVecel (oMMi-1 o1-MB]-1o) aol mm DY: W im BI =vol
= Audio signals
§
POWER -* ON
1 Select the desired program with the FUNCTION
button.
For an FM/AM broadcast, tune in the desired station
2 Set the tape (DAT) deck in the recording mode.
3 Start playback of the selected program source.
Monitoring the recorded sound
if you have connected a 3-head tape deck to the TAPE 2
jacks, you can monitor the recording results. While
recording or dubbing, press TAPE 2 MONITOR so that the
TAPE 2 MONITOR indicator lights up. To listen to the source
sound again, press the button again so that the indicator
goes off.
26
a{-Yorelgollalem-law-\ere|(omcielt ceo m m
ME-Tol-mBLeleleliale)
to TAPE 2 OUT ql
q | to TAPE 1
(or DAT) IN
Tape deck 2°
_ (for recording) -
1 Insert the recorded tape into tape deck 1 (or the
DAT deck).
2 insert a blank tape into tape deck 2 and adjust the
recording level.
3 Press TAPE 1 or DAT to select the deck for
playback.
4 Start the playback of the tape (or the DAT) in tape
deck 1 (or the DAT deck), and set tape deck 2 in
the recording mode.
Dubbing will start.
Note on tape dubbing
Tape dubbing is possible only in the following directions:
From
To
(playback deck)
(Recording deck)
Tape deck
Tape deck connected to TAPE 2 OUT
connected to
TAPE 1 IN
DAT deck connected to DAT OUT
Tape deck connected to TAPE 1 or 2
OUT
:
DAT deck
connected to
DAT IN
Press the FUNCTION button according to the playback
deck.
Advertisement
Table of Contents
