Turning On/Off The Power; The Camera Status With The Led - FujiFilm instax Pal User Manual

Preparation for the camera

Turning on/off the power

1
Press the power button on top of the camera and
hold for 2 seconds.
The LED lights up, and the power turns on�
■ When turning off the power
Press and hold the power button� LED light turns off, and then the
power turns off�
The camera will automatically be turned off after 2 minutes of
inactivity (default setting)� You can change the setting to "5 min" /
"OFF" in the app menu�
7

The camera status with the LED

You can check the status of the camera with the LED�
In both Fun/Link mode
LED state
White pulsing light Bluetooth connection is not established,
but battery level is sufficient�
Red pulsing light Bluetooth connection is not established,
and battery level is low� Charge PAL unit�
Pink light Displayed while taking a photo
Purple pulsing light Displayed during image transfer to the
PAL App�
Blue slow flash Displayed during firmware updating�
Blue fast flash Firmware update error� Recommence
firmware update or contact Fujifilm
customer service / repair center�
Yellow fast flash The Micro SD card is full, or the PAL
(for 3 seconds) camera's internal memory has reached the
50 photo limit of untransferred images�
Connect the PAL camera to the
downloaded INSTAX PAL Smartphone App
via Bluetooth and transfer images via the
App�
Yellow light The battery level is low� Charge PAL unit� If
(for 3 seconds) Yellow Light LED state continues even
after charging, contact your local Fujifilm
customer service / repair center�
Red fast flash PAL unit has become overheated� The
(for 3 seconds) camera will automatically power off after
3 seconds� Allow unit to cool�
In Fun mode
LED state
Blue pulsing light Bluetooth connection with the INSTAX
PAL App is complete�
In Link mode
LED state
Green pulsing light Bluetooth connection with an INSTAX
LINK Series of Smartphone printer is
complete�
Meaning
Meaning
Meaning