Table of Contents
Advertisement
Preparation for the camera
Precautions regarding using an SD card on a PC
Always format an unused SD card or an SD card that has been
used on a PC or other device by inserting it into the camera and
using the INSTAX Pal app before using it in the camera�
* You can format the SD card from the Media settings on the app�
When an SD card is formatted and used for shooting and
recording, folders are automatically created� Do not use your PC to
rename or delete folders or files on the SD card� Doing so may
make the SD card in the camera unusable�
• Do not use your PC to delete images on the SD card� Always use
the INSTAX Pal app�
• If you want to edit an image file, copy or move the image file to a
hard disk or similar device, and then edit the copied or moved
image file�
Charging the battery
Round lamp on
front of camera
lights up during
charging�
Plug USB AC adapter into an indoor
power outlet
Supplied
Connect the camera using the included USB Type-C Charging
Cable to a USB AC adapter (sold separately), and then connect the
USB AC adapter to an indoor electrical outlet / power supply�
• Charging time is approximately 2 to 3 hours�
• The round lamp on the front of the camera will light up when
the camera is charging�
• The power delivered by the charger must be between a
minimum of 1�4 Watts and a maximum of 2�5 Watts in order to
minimize required charging time�
• Charging times may increase at very low or very high
temperatures�
6
Charging status
If the camera is not turned on, the light will turn off after the
battery is fully charged� When the camera is turned on without
being connected to the app, the light turns white after the battery
is fully charged�
FRONT CAMERA LAMP
Charging
Charging
completed
Charging error
* If the camera is turned off, the lamp disappears after the battery
is fully charged� When the camera is turned on without being
connected to the app, the lamp lights white after the battery is
fully charged�
Charging from a PC:
• Connect the camera and PC directly� Do not connect via a USB
• If the PC goes into sleep mode while charging, charging is
• The battery may not be able to charge depending on the
Notes
• The battery is not fully charged at the factory� Be sure to
• For notes about the battery, see "Simple camera care" (page
Not supplied
The light flashes�
The light stops flashing�
The light flashes fast� Check the cables�
Unplug and then re-plug in cables to try
again�
hub or keyboard�
paused� To continue charging, exit sleep mode and then
reconnect the USB Type-C cable�
specifications, settings or conditions of the PC�
charge the battery before using the camera�
29)�
Advertisement
Table of Contents
