Fingertracking2 And Fingertracking2 Tactile Device; Three Active Finger Markers); Fingertracking2 And - Art ARTTRACK Installation Manual

5 System setup
Figure 5.35: FINGERTRACKING2
three active finger markers)
rechargable batteries and a battery charger
FINGERTRACKING2 Tactile
Additionally, the
one vibration motor for tactile feedback on each thimble
radio module in the hand unit for addressing the vibration motors
5.8.3.1 FINGERTRACKING2
On/Off switch Move the switch to the
bration motors are started sequentially as a test run
After turning on the hand target unit, the status LEDs light up according to table 5.7 on
page 94. In Off position the hand target is switched off completely. There is no need to
remove the batteries when not using the devices for a longer period of time.
L/H switch Move the switch to
necessary, e.g. at far distances (> 3 m) from the cameras. Extend the battery lifetime by
switching to L position.
94
and FINGERTRACKING2 Tactile
has:
and FINGERTRACKING2 Tactile
On position to turn on the hand target unit. The vi-
H position to increase the brightness of the IR LEDs if
device (shown with
Hand Targets
(FINGERTRACKING2 Tactile only).