Table of Contents
Advertisement
Top View
Event
green pulse
status LEDs
yellow pulse
yellow (and green)
flickering
trigger, but-
ton
and joystick
Table 5.10: Description of the
In case you need to carry out a factory reset for the
find the reset button just on top of the charging jack. You may use a
paper clip to press the reset button.
5.9.5.2 Data output
The output data consists of:
position and orientation of the Flystick,
status of buttons and joystick,
number of used
Please refer to
DTRACK3 Programmer's Guide
Ethernet
for more information about the format of the output data.
5.9.5.3 Battery pack
The
Flystick3
contains a battery pack inside the device.
Replacing the battery For replacing the battery of the
the back cover first. To this end, loosen the four screws using the 2.5mm hexagon key
and remove the back cover.
Remove the old battery and insert the replacement correctly within the cut-out.
Apply the back cover again and tighten the screws carefully.
Dispose used batteries according to your governmental regulations.
Risk of explosion if battery is replaced by an incorrect type!
Description
button pressed or joystick position successfully
transmitted
button pressed or joystick position could not be
transmitted
low battery, recharge soon
press the trigger or any button to invoke an inter-
action which can be defined in the user application
(e.g. drag objects while button trigger pressed, open
a menu dialogue, . . . )
Flystick2/2+/3
.
5.9 Discontinued hardware
Flystick3
control elements
Output of Measurement Data via
Flystick3
Flystick3
you will
, you have to take off
109
Advertisement
Chapters
Table of Contents
