Ports & Plugs On The Art Controller/M - Art ARTTRACK Installation Manual

5.2.4 Ports & Plugs on the
The following list gives a short overview of all ports accessible to the user (see figure 5.15
on page 56):
ART Synccard3
– 'PoE+ ports':
All ARTTRACK
here. In larger systems (> 6
TRACK5/C
ports.
ART Synccard3
– 'ExtIn':
Please plug in the external source (TTL or video signal or master controller of
a cascaded system) for synchronization here. Please use the port marked 'IN'
only. For configuration refer to chapter 5.5 on page 65. In cascaded systems
please connect the external source to the master controller only.
ART Synccard3
– 'OUT ':
This port is used as synchronization output (video signal) in syncgroup #1. For
backwards compatibility connect
Please refer to chapter 5.2.5.2 on page 60 for more detailed information.
ART Controller/M
ART Controller/M
Figure 5.15:
(IN & OUT) :
as well as TRACKPACK/E
ARTTRACK5
cameras only) connect the external PoE+ switch to any of these
(IN ONLY):
(OUT ONLY):
ARTTRACK1
5.2 Installation of the Controller
back view
cameras have to be plugged in
and 8 ARTTRACK6/M
– ARTTRACK3 cameras here.
or ART-
57