Advertisement
2 SETUP
6
Guideline
Screw, handlebar
clamp
Info
The markings on the handlebar should be at the
center of the handlebar clamps.
Keep the installed gap widths equal when tighten-
ing.
(All Six Days models, 300 EXC TPI ERZBERGRODEO EU)
–
Remove screws
–
Move the handlebar supports to the desired position and
mount and tighten screws
Guideline
Screw, handle-
bar support
Info
Position the left and right handlebar supports
evenly.
S01415-10
Warning
Danger of accidents A repaired handlebar poses a
safety risk.
If the handlebar is bent or straightened, the mate-
rial becomes fatigued. The handlebar may break
as a result.
–
S01413-01
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned cor-
rectly.
–
Position the handlebar clamps. Mount and tighten the
screws evenly.
Guideline
Screw, handlebar
clamp
M8
3
and take off the handlebar supports.
3
.
M10
40 Nm (29.5 lbf ft)
Change the handlebar if the handlebar is dam-
aged or bent.
M8
20 Nm
(14.8 lbf ft)
Loctite
®
243™
20 Nm
(14.8 lbf ft)
Advertisement
