Table of Contents
Advertisement
. Pump the brake lever several times
until pressure can be felt. Hoid the
lever tight, open the bleeder valve by
about one-half turn and squeeze the
lever all the way down.
Do
not
release
the lever until the
bleeder valve has been closed again.
Repeat this procedure until bubbles
cease to appear in the fluid at the end
of the hose.
. Remove the bleeder hose, tighten the
bleeder valve and install the bleeder
valve dust cap.
. Do not allow the fluid reservoir to
become
empty
during the bleeding
operation as this will allow air to enter
the system again. Fill the reservoir as
Often as necessary while bleeding.
. Check for absence of leaks in the front
brake
lines while
holding
pressure
against the brake lever. Fill the reser-
voir when bleeding is completed. Rein-
58
stali the diaphragm, washer and reser-
voir cap and tighten.
When the hydraulic brake system has
been drained, fill as outlined below:
8. Fill the fluid reservoir,
NOTES:
* Brake fluid which has been pumped
out of the system must not be used
again.
Advertisement
Table of Contents
