Table of Contents
Advertisement
mm wrench.
. After the oil stops draining from the
crankcase,
operate
the kick starter
several times to drain any oil which
may
be left in the recesses of the
engine.
. When
the oil has been completely
drained, reinstall the drain plug ©,
making sure that the O-ring used on
the drain plug is in good condition.
5. Fill the crankcase through the oil filler
opening with approximately 2.1 US
quart (2 liter) of recommended grade
oil. Check the oil level with the filler
cap dipstick; however, when making
this check, do not screw in the cap. Oil
level should be between the upper ©
and lower (9 level marks (page 34) on
the dipstick. When checking the oil
make certain that the motorcycle is in
upright and level position.
NOTES:
- И the oil is below the lower level mark
on the dipstick, fill to the proper level
before operating engine.
* When
operating the motorcycle in
unusually dusty conditions, the oil
changes must be performed at more
frequent intervals than those specified
in the maintenance schedule.
35
Advertisement
Table of Contents
