Honda CB360 Owner's Manual page 52

5. Check the clearance of both valves by
inserting the feeler gauge © between
the tappet adjusting screw @ and the
valve stem. If clearance is correct there
will be slight drag or resistance as the
gauge is inserted. If clearance is too
close or loose, adjustment is necessary.
The standard tappet clearance is
In. 0.002 in. (0.05 mm)
Ex. 0.003 in. (0.08 mm)
6. Adjustment is made by loosening the
adjusting screw lock nut @ and turning
the adjusting screw Ф until there is
slight drag on the feeler gauge ©. Hold
the tappet adjusting screw in this
position and tighten the lock nut @.
Recheck the clearance with the gauge.
G Adjusting screw
64) Adjusting screw ® Feeler gauge
@ Inde: mark о "LT" mark
44