Honda CB360 Owner's Manual page 50

. If left cylinder ignition timing is іп-
correct, loosen the base plate locking
screws @, and rotate the base plate @
to obtain correct timing. Rotate the
base plate clockwise to advance
timing, or counterclockwise to retard
timing. Tighten the base plate locking
screws and recheck left breaker point
Bap.
. Тит the generator rotor coun-
terclockwise until the "Е" timing
mark ® on the rotor aligns with the
index mark @ on the generator stator
G. If right cylinder ignition timing is
correct, the right breaker points will
just begin to open as these marks align.
. К right cylinder timing is incorrect,
loosen the right breaker plate locking
screws @, and increase or decrease
point gap to obtain correct timing. Do
not loosen the base plate locking
screws @. Increasing the point gap
42
_ ад :
advances ignition timing. Decreasing
the point gap retards ignition timing.
@ L/H contact breaker plate locking screws
® R/H contact breaker plate locking screws
NOTE:
Ignition point gap must remain within
limits of 0.3—0.4 mm (0.012—0.016
in.) after ignition timing has been set.
If correct timing results in a point gap