Introduction - Siemens SIMATIC ET 200eco PN M12-L System Manual

Introduction

Purpose of the documentation
This documentation provides you with important information on configuring, installing,
wiring and commissioning the SIMATIC ET 200eco PN M12‑L distributed I/O devices.
The ET 200eco PN M12‑L I/O devices are the innovation of the proven product family
ET 200eco PN. You can recognize the I/O devices of the new innovation level by the suffix
M12-L.
Basic knowledge required
This manual requires general knowledge of automation engineering.
This manual contains a description of the components that were valid at the time the manual
was published. We reserve the right to issue a Product Information which contains up-to-date
information about new components and new versions of components.
Validity of the documentation
This documentation applies to the SIMATIC ET 200eco PN M12‑L distributed I/O devices.
Safety of the plant or the system
Safety is the responsibility of the assembler
The safety of any plant or system incorporating the equipment is the responsibility of the
assembler of the plant or system.
Conventions
Also observe notes marked as follows:
NOTE
A note contains important information:
• On the product described in the documentation
• On handling the product
• On the part of the documentation to which special attention is drawn, as this can result in
damage.
8
Distributed I/O system ET 200eco PN M12-L
System Manual, 11/2023, A5E48753295-AG
1