Table of Contents
Advertisement
DMT-8v Owner's Manual (Names and Functions)
md
Refer to "2. Switching the display using the DISP SEL key."
то снаве
Тыз message flashes when the "Slave mode" in the setup mode is set to "ON." It will
light up when the lock operation is complete
в carr UNDO
If you try to perform Auto Punch In/Out recording after the DMT-8v1 enters Auto
Punch In/Out mode, this message appears to warn you that you will be unable to
undo the recording even f you can record. because there is not enough Undo area
'on the disk
з. сомғитео
This message indicates that an operation such as copy, move, and paste has been
completed.
за sune?
This message is shown to confirm whether or not you wish to execute a certain
operation.
|. LOAD, SAVE, FORMAT, MTC OFFSET, FRAME РАТЕ, MIDI SYNC OUT, TEMPO, BAR,
When the DMT.8vt enters Setup mode, the preceding words appear as names for
the parameters
being set.
замо
3. Switching the display using the DISP SEL key.
Lets assume that you turned ff the power while the time display was using atime
base of "ABS" and then you turned the power on again. The DMT-Bv.
ime display
Advertisement
Table of Contents
