Table of Contents
Advertisement
DMT-811 Owner's Manual (Names and Functions)
40. Clipboard
in key [CLIPBOARD IN]
When audio data is copied or moved, the start point of the copied part is stored in
memory. Pressing this key following the RECALL key (or pressing only this key) will
show the stored data on the display and the recording section will enter edit mode.
їп edit mode, use the HOLD/» key or е dial to move around the digits, and use
the jog dial to increase/decrease
the value.
you press this key following the STORE key after the edit operation, the edited
value will be stored into the key memory.
The data stored by this key can be used to locate data.
This memory is reset to the factory default value when the power is turned of.
Eel
Rak u pega S ж
rci Pa CUPBOARD Nor
41. Auto Play/Auto Return key [AUTO PLAYIAUTO ИТМ]
Pressing this key repeated wil change Auto Pay mode, Auto Return mode,
and Repeat mode On/Off as follows: (O: LED off, Ө: LED light up)
E
Ars rey OM (Quy като RAY LED)
E
ae ata OM (Oni ња AUTO ТО и)
et Pepe ON (bot AUTO PLAY an AUTO TN LED we.)
Aio Pay тоби.
Tn this mode, playback wil start automatically after the START point is located.
This funcion is effective at any locate points other than the ARS END point
Auto Return mode:
When the END point s reached during playback, the START point is automatically
located
in this mode. This function s effective only when the START and END
points have been specified.
[ae
| eo Ren treten ас эн ig ана. а ring md Me STAAT pt wl
reamed cesta ane be DO porta vete
Auto Repeat mode:
'This mode is a combination of Auto Play and Auto Return, and plays back the part
between the START and END points repeatedly. The auto repeat function i effective
'only when the START and END points have been specified correctly.
rr
aran
JJ
42. Display Select key [DISP SEL]
This key is used to change the display mode. Pressing
this key repeatedly will
'change the display mode as follows:
[=== р
23
Advertisement
Table of Contents
