Table of Contents
Advertisement
Мт ва. Owner's Manual (Names and Functions)
эз. Record button [RECORD]
Pressing only this button places the readied tracks into input monitoring status.
Pressing this button again wili reset the tracks to playback monitoring. (The RECORD.
LED will blink when the readied tracks are under the input monitoring status.)
Pressing this button while holding down the PLAY button will place the readied
tracks into recording. A this time, the PLAY LED and RECORD LED wili be Iit, and
he readied track indication wil be it steadily (instead of blinking).
"tr page 3F af na а opor ra а sain өө тот rl
pete
34. Paste key [PASTE]
Press this key to copy data or move data that has been copied to the clipboard to a
location stored at the AUTO PUNCH IN key. The data will be pasted at the point
stored in the Auto Punch In key. You can select the paste destination track using
"he RECORD
TRACK select key. A destination track to which data в pasted и identical
to the source track.
"This key ls activated only when the recorder transport section ls topped.
Ratt раци t more rimane ecu тө Copy А Рана ала ove Раны оревот
эв. Locate
key [LOCATE]
Press this key to locate a data point.
The ран wili locate the point stored in the CLIPBOARD IN/OUT key, AUTO PUNCH.
IN/OUT key, or AUTO RTN START/END key when you press the corresponding key
and then press the LOCATE key.
The LOCATE key has a memory and stores the previously Jocated point.
'Therefore, you only need to press this key to locate the same point repeatedly.
To check the memory of the LOCATE key, pres the RECALL key, then the LOCATE
key. You can also store a locate point by pressing the STORE key, then the LOCATE
key after you edit data using the JOG dial and/or the HOLD/> key.
When you tun off the power to the MT а, the memory wil be reset to the factory
default setting.
ари
а
ы
)
38. Auto Punch Mode ОМО key [AUTO PUNCH]
"Switch this key ON for auto punch in/out.
When you press this key while a correct value s stored to the AUTO PUNCH IN key
and the AUTO PUNCH OUT key, both the REHEARSAL LED and TAKE LED wil blink,
indicating that Auto Punch mode îs on. (If a correct value в not stored, pressing.
the AUTO PUNCH key will not turn the parameter ON, and the message "Vold Out"
wall appear)
Pressing the PLAY button under this condition wil put the unit into "Rehearsal
mode" for Auto Punch In/Out recording. Pressing the PLAY button and RECORD
button simultaneously
will put the unit into "Take mode."
There are five combinations of tbe REHEARSAL LED and TAKE LED that indicate the.
satus of the unit regarding auto punch recording:
21
Advertisement
Table of Contents
