Table of Contents
Advertisement
(Cera rma
manta
лано)
This key в wed to enter into the clipboard data stored in memory by the CUPBOARD
IN/OUT keys. Pressing the MOVE key wil store the data in the Clipboard as Move
data, To enter data to be moved, one or more tracks must be readied, and a correct
value must be stored for the In and Out pints.
M you attempt to enter data when а tracks are safe, all track indications and.
"SELECT trk indication on the display wil blink to warn you. Ifa correct value Is
not set for the Clipboard In or Out, a warning message of "Void In" or "Void Out"
wit appear.
[ме елу
он пак de Он А ан et ve ниот)
This
key is used to сору data stored in the memory using the CUPBOARD IN/OUT
keys. Pressing the COPY key wi store the data а the Clipboard аз Copy data.
To execute the copy operation, one or more tracks must be readied, and a correct
'value must be stored for the In and Out points. If you attempt to copy data when all
racks ace safe, all track Indications and a "SELECT trk" indication on the display
'wil link to warn you. Ifa correct value is mo set for the Clipboard In or Out
points, "Void ош" warning wil appear.
eren err on rmt aed ra oea
е ој
38. Clipboard Out key {CLIPBOARD OUT]
When audio data is copied or moved, the end point of the copied part is stored in
'the memory. Pressing this key following the RECALL key (or pressing only this key)
МЇ show the stored data on the display and the recording section enters edit mode.
та edit mode, use the HOLD/> key or shuttle dial to move around the diis, and use
the jog dial to increase/decrease
the value.
If youpress this key following the STORE key after the edit operation, the edit value
wil be stored into the key memory. The data stored by this key can be used as
locate data. When you turn the power to the ОМ Би. the memory will be reset to
the factory default setting-
рането papa чо an тоу ау CUPBOARD CUT pame |
ts
2
Advertisement
Table of Contents
