Stamina AeroPilates Pilates Home Studio 55-5107 Owner's Manual page 10

ASSEMBLY INSTRUCTIONS
STEP 6
Remove the paper covering from the foam tape inside the REAR COVER(4). Place the REAR COVER(4)
over the end of the REAR FRAME(2). Press the cover securely in place.
STEP 7
Insert the PULLEY RISERS(25) into the mounting holes in the REAR COVER(4) and REAR FRAME(2). Insert
the PULLEY RISERS(25) all the way to the bottom. Align the threaded holes in the PULLEY RISERS(25) with
the holes in the REAR FRAME(2) and secure with the LOCKING KNOBS(26), but don't tighten the knobs.
Attach the PULL-UP BAR(59) to the PULLEY RISERS(25) with BUTTON HEAD BOLTS(M8x1.25x42mm)
(58) and ARC WASHERS(M8)(57). Tighten the LOCKING KNOBS(26).
STEP 8
Refer to the detail drawing below showing an enlarged view of the left PULLEY RISER(25) and the LEFT
PULLEY HOOK(23). With the pulley facing down, insert the LEFT PULLEY HOOK(23) into the left PULLEY
RISER(25) from the inside as shown. Swing the pulley forward as shown and the LEFT PULLEY HOOK(23)
will be in position for use. Use the same procedure to install the RIGHT PULLEY HOOK(24) on the right
PULLEY RISER(25).
Use the hole at outer
side for assembly.
10