Table of Contents
Advertisement
MUUTLEDIT MODE
A maximum of seven commands can be programmed into MULTI
COMMAND button. This enables a series of signals to be transmitted
simply by pushing the MULT! COMMAND
button.
{Example} Programming the following three commands
into the
MULT! COMMAND button.
@ RECEIVER POWER
@ RECEIVER FUNCTION CD
® CD PLAY (>)
1, Press the EDIT button. {Switches to the EDIT mode}
The VCR 1, VCR 2, and TV CONTROL MODE buttons flash in
sequence.
2. Press the MULT! COMMAND button. (Switches to the MULTI
EDIT mode)
®The CONTROL MODE buttons flash at random.
3. Press the RECEIVER POWER button.
® The CONTROL MODE buttons go out, and then flash atrandom.
(Registration is completed)
4, Press the CD receiver input selector button.
® The CONTROL MODE buttons go out, and then flash atrandom.
{Registration is completed)
5. Press the CD CONTROL MODE button.
® The CD button flashes.
6. Press the PLAY (=) button.
® The CD button goes out, and then the CONTROL MODE buttons
flash at random. (Registration is completed)
2. Press the MULT! COMMAND button.
®The CONTROL MODE buttons light in sequence. (This means
that registration has been completed), and then the VCR 1,
VCR 2, and TV buttons flash in sequence.
8. Press the EDIT button.
® The EDIT mode is canceled.
lf you press the MULTI COMMAND
button, these remote control
signals are transmitted in the order programmed, so if CONTROL IN/
OUT is connected {refer to page 16), and if remote control signals
can reach both the receiver and CD player sensor windows, power to
the receiver switches on, the input selector switches to CD, and the
CD player starts playing. (When the CD player's power cord is
plugged into the receiver's switched AC OUTLET.)
NOTE;
® After memorizing six or less commands, if you cancel the EDIT
mode without pressing the MULTI COMMAND button again, all the
registered commands are cleared, leaving the previous commands
as they were.
® /fa button is for transmission, even if itis not an operation button in
the selected CONTROL MODE, registration is still possible. (Buttons
such as the VCR 7 te<,)
In this case, during signal transmission,
the CONTROL
MODE
button momentarily lights, but the remote contro! code is not
transmitted.
® /f the component to be operated is installed ata distance, if there is
an obstacle between a specific
component sensor windaw and the
remote
control, or if component
operation speeds are very
different, MULTI-COMMAND
operation may be incorrect.
When
repeating operations, first return to the initial settings for each
component. For operations such as power ON/OFE if components
are switched ON, they can be switched OFF by transmitting a signal.
REMOTE CONTROL OPERATION
RETURNING TO THE INITIAL SETTINGS
__|
Initialization of particular CONTROL MODES
1, Remove the battery compartment cover.
2. While pressing the M.CLEAR button inside the cover, press
the button for the CONTROL MODE (for example, VCR 1) that
you want to initialize.
® For example, if you initialize VCR 1 using the method mentioned
above,
the CONTROL
MODE
button
lights for about
one
second, and the VCR 1 operation buttons are initialized.
M.CLEAR button
Initializing the entire memory
1. Remove the battery compartment cover.
2. While pressing the M.CLEAR button inside the cover, press
the RESET button.
* Do not release the M.CLEAR button before releasing the RESET
button. While pressing the M.CLEAR button, press the RESET
button, and quickly release.
Initialization is not possible if the buttons are pressed in the
reverse order.
¢ All the CONTROL MODE operation buttons are initialized, and
data in the MULTI COMMAND
button is cleared.
M.CLEAR button
37
<ARB1489>
Advertisement
Table of Contents
