Table of Contents
Advertisement
Follow the steps below for each of the installed rear cameras (note that each camera should be
connected separately to the junction box when performing the calibration):
.
To verify the correct angel adjustment (Y axis) and adjust if needed, run the ME Toolkit
application and check the image – good calibration will display the bottom part of the TAC board
at the bottom part of the image.
If it does not, slightly change the camera angle (camera housing) physically up/down to adjust
correctly.
Mobileye Shield+ V2.0| January 2022
Installation Manual v1.1
Mobileye Proprietary and Confidential
support@mobileye.com
MOBILEYE, AN INTEL COMPANY
WWW.MOBILEYE.COM
Advertisement
Table of Contents
