Tunturi E504 Owner's Manual page 5

4. Attach the rear frame to the front
frame.
Slide the front frame tube into the
rear frame tube until the seat rail
is positioned at the desired
length. (Refer to illustration #3.)
Tighten the adjustment pin.
5. Attach the right pedal to the right
crank.
Gently press the right pedal onto
the right crank. Use the 15mm
open-end wrench to tighten the
bolt at the base of the pedal. Turn
clockwise to tighten. (Refer to il¬
lustration #4.)
NOTE: Each pedal is identified with
an ''L"oran "R" on the inside edge.
3
6
. Attach the left pedal to the left
crank.
Gently press the left pedal onto
the left crank. Use the 15mm
open-end wrench to tighten the
bolt at the base of the pedal. Turn
counterclockwise to tighten. (Re¬
fer to illustration #4.)
7. insert two size AA 1.5 volt batter¬
ies into the battery holder. (Refer
to illustration #5.) The orientation
of the batteries is indicated inside
the battery holder.
8
. Attach the electronics module to
the front frame.
Connect the electronics cable on
the front frame to the electronics
module, insert the electronics
module onto the bracket located on
the front frame, then secure the
module with two M4x10 round
head bolts. (Refer to iliustraction
#5),
4