Kenwood TH-225A Instruction Manual page 19

эмм. MOUNT Мело HEADPHONES
BH-5 HS-7
| proonammaste томе
pl
|7804, rascomw antena HS-8 |
и, ВАЗ moste мошта
os
MB-4
uw 59
POWER SUPPLY
NLCA RECHARGEABLE NECA RECHARGEABLE АА MANGANESE,
оа БИШИ ШУШЫ,
Zie L1 LE 3
ЕЯ Be a snn
|же IPINTEN BC-2 „зым,
| PB-1 аи Е
seis u ЕЗ PB-12 B
BC-7, COMPACT CAMROER
Lo BC-8
[m
Nore:
Some optional accessories may not be available in your areas.
'Some cars may not be suitable to hook the MB-4 into the window.
HMC-1 vox headset cannot be used.
E PROGRAMMABLE TONE DECODER
UNIT (TSU-4) Fig. 1
Front panel
1. Remove the four phillips head screws from the rear panel
of the radio.
2. Gently remove the front panel. The panel should be го-
tated away from the PTT switch side,
3. Remove the foam cushion attached to the bottom of the
set. Install the tone squelch unit between the bottom of
the set and the main circuit board as shown in Fig. 1.
4. Attach the cable from the TSU-4 as shown in Fig. 2. The
cable should be routed under the ribbon cable that goes
to the front panel.
5. Remove the backing from the foam cushion that was pro-
vided with the TSU-4 and attach the cushion to the edge
of the 790-4.
6. Replace the covers and tighten screws to complete the
installation.
19