Table of Contents
Advertisement
Remote control operation
& Loading batteries into the remote control
unit
1. Remove the battery cover.
While gently pressing the battery cover located on the
rear of the remote control unit, slide it in the direction
of the arrow.
2. Insert the provided batteries. Take care to respect the
battery polarity (+, —).
Note:
The batteries provided are to be used for checking the remote
control operations. Their service life may be short.
@ Battery replacement
1. if the TRANSMIT
indicator will not light up when an
operation
key is pressed,
the batteries
may
be ex-
hausted. In this case, replace them with new batteries.
It is recommended
to use alkaline batteries (LRO3 or
AM-4 type) with long life.
. The programmed
contents
are not immediately lost
when the batteries are removed for replacement. How-
ever, they could
be lost if the unit is left without
batteries for more than 3 minutes. In such a case, the
programming should be performed again. The function
signals of the non-learning, or fixed, keys are not lost
even in this case.
NO
Note:
Avoid using old and new batteries together, as this may cause
corrosion.
@ Operations
1. Connect
the power
plug of the receiver to an AC
outlet.
© The receiver enters the power standby mode and the
power standby indicator lights.
2. Press the POWER key of the remote control unit or the
POWER
key of the receiver.
© The receiver enters the power ON mode.
3. The various functions of the receiver can be operated
with the keys of the remote contro! unit.
Note for remote control operation
After
pressing
one
of the operation
keys, when
the next
operation is required, press the next operation key firmly after
an approx. 1 second interval.
lf the next operation
key is pressed
immediately after the
previous key, misoperation may result.
@ Operating
range
of the remote
control
unit
The operating range of the remote control unit may differ
according to temperature, humidity, or using conditions,
however,
it is defined
approximately
as shown
in the
figure below:
For controlling the receiver, TV and VCR
Remote control sensor of the
receiver, TV or VCR.
The signal transmission system
used by this remote control unit
is the infrared control system.
Note:
Malfunction may occur in case direct sunlight or the light of a
high — frequency lighting fluorescent
lamp enters the remote
control light recepter. In such a case, change the installation
position of the unit so that the malfunction does not occur.
KR-V9020 (En)
35
Advertisement
Table of Contents
